Cards and Bits Box

The Cards and Bits Box is the ultimate accessory for your board game or card game evening!

It was designed in such a way that the lid of the box can be slid over the body of the box, whereby there are two so-called card grooves in both the lid and the box itself, in which the most diverse cards of a board game or card game can be conveniently lined up. The angle of the card groove has been adjusted so that the cards tilt slightly backwards. This gives a good view of the cards without the risk of them falling out. This leaves the player’s hands free to concentrate on the game itself or to indulge in „culinary delights“ 😉

The box body itself also has several, individually adjustable compartments for storing additional game pieces and game pieces. The inner walls that separate the box compartments can be easily pushed up and removed, allowing the compartments to be adjusted variably in number and size. The bottom of the compartments contains a slight curve at the bottom so that even flat tokens can be pushed upwards with the fingers. This makes it very easy to remove the game pieces from the respective compartment.

However, the Cards and Bits Box is not only very useful for the actual game. It can also be used as a storage box for tiles and game pieces. The sliding mechanism with which the lid is pushed over the box body has been adapted so that the game pieces and game pieces remain in their respective compartments, even if the box is shaken strongly. This way, the game pieces always stay neatly sorted.

The dimensions of the box have been adapted so that it fits into the most common board game boxes. In this way, the game pieces and game pieces can be neatly sorted and do not fly around in the box. The annoying sorting into sealable plastic bags is also no longer necessary.

For an additional charge, the lid of the Cards and Bits Box can be provided with a name or a logo.
The logo must be in JPG format and have the following characteristics:
– Greyscale image
– Length = xx cm
– Width xx cm
The partition walls can also be used with a name or logo for an additional charge.
The logo must be in JPG format and contain the following properties:
– Greyscale image
– Length = xx cm
– Width xx cm